What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
13.06.2025 02:30

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
It also is a device that limits the change in current flow.
At least they know the answer if they wanted it.
The MOV will conduct when the voltage exceeds 50% of line voltage.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
What's an underrated/unknown novel or series that you think deserves more attention?
One is “what exactly is in a ‘surge protector’ ? ”
What does a fuse do?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Why do I get spun and then want big fat cocks to suck?
One
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
a photo is worth a thousand words.
It seems Mohan does not understand the difference between a comment and an Answer.
This is where the MOV conducts again, and dissipated the energy.
nine
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Barnstars:
the problem then depends on "how fast does the fuse operate?".
Now when you have a certain ac resistance, then a current flows in a loop.
The bolt then partially travels down the line to your home.
This device then solves the entire problem.
(Dc diagram shown, AC is similar).
He then asserts :
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Why do men prefer low-maintanence women?
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
But… the neutral is now “floating” because of the 1 ohm resistance.
But it can get overloaded, and no longer works.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
At one ohm, the resistor has a maximum of 1 watt power.
[old diagram got deleted by accident]
There are three different concepts here that are getting confused.
The other is “what does a “fuse” do?”
An AC voltage/ current source, and an ac inductive load.
A circuit breaker is similar, but is resettable.
What is lightning?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
These devices are installed between the “hot” and “neutral” and protective ground.
2024–10–10[John johnson John Johnson ]
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Because the load is inductive, the current lags the voltage.(by a bit).
He then describes the function of a fuse.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
so, what happens?
2024–10–14 [Omar Gharbi Omar Gharbi ]
This is where this question deviates from being a 'generic' question, and becomes more specific.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
but I think this circuit , shows a few more pieces.
Upvotes:
A fuse is a non-resetable over current circuit protector.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
eight
So, the voltage could go up to 500 volts, and the fuse will not open up.
The third is lightning and “how it gets conducted into a home.”
but this device (an Inductor) … impedes the rapid changes in the current.
For this case there are devices called Metal oxide varistors (MOV).
There are two important concepts here.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This one hit behind the barn.
[image of Common-mode choke]
Edit 2024–10.
This is 'the assistant's answer'
He then describes Rainy Season and Lightning.
In schematic diagrams this is the symbol for a fuse:
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
I post the exact comment here.
what exactly is a ‘surge’ protector?
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
First Sentence:
Here is a simplified AC power diagram.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
These are simplified answers to the original question, and does not change anything I wrote above.
2024–10–16 [ OO OLAOYE OYEBODE ]
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.